PRODUCTION AND SUPERVISION

Review cycles and stoppages during the shift.

Review machine records and document stoppage reasons where they occur, using a recording procedure suited to your operation.

Reconstructing events at the end of a shift often means losing detail. The duration of a stoppage, its cause and product changeovers may be documented by different people in different records.

PRODUCTION / SHIFT SEQUENCE

What happens between two parts also matters.

Combine recorded cycles and available machine states with production-team notes to examine output rate, stoppages and product changeovers.

KERN IoP | SMARTPRO beside the control panel of an injection-moulding machine.
KERN IoP | SMARTPRO installed beside an injection-moulding machine.

CYCLES

Counts and durations where a reliable cycle signal is available.

STOPPAGES

Detected intervals and causes recorded by personnel or the system.

END-OF-SHIFT REVIEW

Output, operating time and losses based on consistent rules across machines.

VISIBILITY ON THE PLANT FLOOR

Real-time data to support decisions during the shift.

Displaying machine status during production makes it possible to identify stoppages or falling output rates before a shift ends. Instead of serving only as a historical record, the information becomes an operational reference for supervisors, production and maintenance teams.

Where production orders include a target quantity and product reference, progress monitoring can also help estimate when the run will finish and when the next mould, material or product change should be prepared.

KERN IoP MONITOR screen in ANDON mode installed on the shop floor to display machine states in real time.
KERN IoP | MONITOR in ANDON mode: production status displayed directly on the plant floor. Interface shown in Spanish.

01 · STATUS

Identify stoppages and reduced output rates

Seeing which machines are producing, stopped or running below the expected rate enables teams to respond while a loss is still occurring.

02 · PROGRESS

Prepare the next changeover

With target quantity, actual counts and product reference available, order progress can help coordinate moulds, materials, personnel and changeover activities in advance.

03 · CAUSES

Focus improvement on the largest time losses

Consistent stoppage classification reveals which causes account for the most lost time or recur most frequently, helping prioritize improvement work.

04 · CONTEXT

Connect machine signals with actual events

Automatically collected data become more informative when complemented by product references, stoppage causes and operator notes needed to interpret the shift.

PRODUCTION · FURTHER ANALYSIS

Is the shift losing time to stoppages or longer cycles?

Production teams need to know how much time the machine was stopped and how much time it operated below its planned rate. Combining cycle signals, stoppage classifications and product identification allows these losses to be examined separately.

SMARTPRO displays machine status and production order.
Interface shown in Spanish.

Which records are needed to distinguish them?

Identify planned time, actual cycles and a valid ideal cycle time for the product. Operator records entered through SMARTPRO help explain why stoppages occurred.

Other questions: Quantify lost capacity · Records at the machine · Include quality data during the shift

This reflects an approach to Industry 4.0 that strengthens operators and production managers: data should support decisions during the shift and subsequent verification of improvements.

A PLANT-FLOOR EXAMPLE

Before drawing conclusions.

A cycle signal reveals machine activity and output rate. Calculating complete OEE additionally requires scheduled time, a valid ideal cycle time and good-part quantities. Dashboards should display only indicators supported by the available data.

RELATED CONTENT

KERN MONITOR

Access to historical records and variables.

OEE calculation

Data required for each OEE component.

TO INVESTIGATE FURTHER

Investigate stoppages using operating records

Relate machine states, production logs and maintenance interventions to understand the effect of each stoppage.

Read the technical guide →

APPLICATION ASSESSMENT

Request a production-monitoring demonstration

The demonstration should cover an operator task and a supervisor review: recording a stoppage, changing a product reference and examining the period. Available features are confirmed for the proposed configuration.

Describe your needs using the information available. You do not need to attach confidential data.

← Back

Thank you for your response. ✨

Privacy and Personal Data Processing Policy


PM Tec Engineering, through its Industry 4.0 division, KERN IoP.
Cota, Cundinamarca · Colombia.

Privacy policy